Kart Parts There are 130 products.
Nassa Panel Top Brackets 2 off A pair
Cheetah Crank Shaft Nut
17 mm nut, 2 per Cheetah engine 1 for the clutch drum, 1 for the flywheel. A small dot of thread glue is recommended during replacement
chassis plug 30mm
Actually they are BLACK plastic This is the plug that goes in the end of the chassis rail.(at the back UNDER THE axle) For when neatness counts
Clutch Drum and 10 Tooth Sprocket suit IAME X30 KA100...
Clutch Drum suit IAME X30 , KA100 , RL Leopard or Cheetah 10 Tooth 4 bolt sprocket
Plastic Spacer Washer M6
Plastic Spacer Washer M6 Normally used on front crash bars as a bush.
Stub Axle Bearing Spacer 10mm ID x 26.5mm Long
Stub Axle Bearing Spacer 8mm ID x 26.5 mm Long This is the spacer that goes between the top and bottom bearings in stub axle spindles
Blanking Plug For Temperature Sensor Hole
Blanking Plug for temperature sensor hole with copper washer thread M10 x 1 ( standard fitting )
Wheel Nuts Pack of 12 7075 Ultra Light Wheel Nuts
Wheel Nuts Kartelli Corse 7075 ultra light weight wheel nuts Pack of 12.
Air Box Internal Filter RED NOTE: NOT IAME BRANDED
Internal air filter and rubber RED type Cheetah and X30 if your not racing AKA
chassis plug 32mm
Actually they are BLACK plastic This is the plug that goes in the end of the chassis rail.(at the back UNDER THE axle) For when neatness counts