Rotax Tool For Fitting Sprocket To Rotax Part No.: 277364
tlrotspk
$74.95
Tax included
Rotax Tool For Fitting Sprocket To Rotax Part No.: 277364
Easy way to hold a Rotax sprocket drum to replace the engine sprocket.
ROTAX PART No. 277364
Makes it EASY, can be done in a couple of minutes
METHOD
Simply slide the tool on the correct size sprocket
Take a 38mm socket or spanner
to unscrew the holding nut
Remove the sprocket from the drum
Fit the new sprocket
A drop of loctite on thread,
and then replace the nut
Using the Tool Again put the sprocket
back in and tighten the nut firmly
Make sure the locating pin was
correctly and securely located
16 other products in the same category:
Front Crash Bar EXTENDED FRONT
Front Crash Bar extented front Install these bars to extend the front if you are too tall for the standard setup Suits Torismo and SQ Karts
$74.95
Tax included
Spark Plug Cap NGK TB05EMH Black
$34.95
Tax included
Wheel Stud M8 suit hub
Wheel Stud M8 suit front and rear hubs GO KART STEEL WHEEL STUDS Wheel Stud 8mm thread for use on all modern Racing
$2.75
Tax included
Rotax Reed Petal - Each Rotax Part No.: 224430
$22.95
Tax included
Kart Clutch Short Shaft 11 Tooth Yamaha KT100 S -...
$339.95
Tax included
NOSECONE SENIOR KG FP7 BLACK
$132.95
Tax included
Magnesium Rims CADET Bearing Front 5 inch set of 4
$349.95
Tax included
Stub Axle Bearing Spacer 8mm ID x 24.4 mm Long
$3.49
Tax included
Universal Chain Guard Black
$16.95
Tax included
Rotax Main Jet 155 Rotax Part No.: MJ155
Rotax Main Jet 155 Rotax Part No.: MJ155
$5.95
Tax included
Kartech Pedal Stud Machined
$8.95
Tax included
Camber Caster Standard. Suit M8 King Pin and 22mm...
Camber Caster Standard. Suit M8 King Pin and 22mm chassis hole
$44.95
Tax included
Number Plate Senior Rear Yellow
$8.95
Tax included
Water Hose Silicon 1.32 Meter with 90 Degree bend -...
$32.95
Tax included
Steering Column OTK compatible - Italian Quality
$69.95
Tax included
Rotax Tool For Fitting Sprocket To Rotax Part No.: 277364
Easy way to hold a Rotax sprocket drum to replace the engine sprocket.
ROTAX PART No. 277364
Makes it EASY, can be done in a couple of minutes
METHOD
Simply slide the tool on the correct size sprocket
Take a 38mm socket or spanner
to unscrew the holding nut
Remove the sprocket from the drum
Fit the new sprocket
A drop of loctite on thread,
and then replace the nut
Using the Tool Again put the sprocket
back in and tighten the nut firmly
Make sure the locating pin was
correctly and securely located