

16 other products in the same category:
Front Crash Bar extented front Install these bars to extend the front if you are too tall for the standard setup Suits Torismo and SQ Karts
The is a 50mm rear axle bearing Suit most karts ID ( inside diameter ) = 50 mm OD ( outside diameter )
Plastic Spacer Washer M6 Normally used on front crash bars as a bush.
Number 3 Black Large on Yellow background
11 Tooth Front sprocket to suit Yamaha KT100S clubman
Rotax Gasket Cylinder Base 0.5mm Rotax Part No.: 650481
Kart number decal red small number 8 suit side pods. Made in three layers for easy application from 3M ScotchCal. AKA approved font and size.
Actually they are BLACK plastic This is the plug that goes in the end of the chassis rail.(at the back UNDER THE axle) For when neatness counts
MG Green REART Tyre ONLY. Very Sticky Wanna Go Fast, this is the tyre.