Sniper Camber Caster Adjuster Bottom Plate
cambercastersnipplate
$42.20
Tax included
Sniper Camber Caster Adjuster Bottom Plate
Suit 8mm and 10mm King Pin version
SNIPER LOWER CASTER PLATE for
KING PIN CAMBER/CASTER ADJUSTER
PLEASE ENSURE THAT THE MOUNTING SECTION ON THE CHASSIS IS FLAT.
DO NOT OVER TIGHTEN THE COUNTERSUNK SCREWS USED TO SECURE IT TO YOUR KART.
THIS COULD LEAD TO A BREAKAGE OF THIS COMPONENT.
A locking fluid is recommended on the two countersunk screws
16 other products in the same category:
Number 5 decal Large black sticker
art number decal Black large number 5 suit nassa panel or number plate. Made in three layers for easy application from 3M ScotchCal. AKA approved font and size.
$1.95
Tax included
Number 2 decal Small red sticker Suit side pods
Kart number decal red small number 2 suit side pods. Made in three layers for easy application from 3M ScotchCal. AKA approved font and size.
$0.95
Tax included
Tyre set MG Yellow
$274.95
Tax included
Stub Axle Bearing Spacer 10mm ID x 22mm Long
Stub Axle Bearing Spacer 8mm ID x 23mm Long This is the spacer that goes between the top and bottom bearings in stub axle spindles
$3.49
Tax included
Spring Exhaust Header 90mm
$1.95
Tax included
Side Pod Bar Suit Evolution Both early model
Side Pod Bar Suit Evolution Both Budget model
$77.00
Tax included
RED CLUTCH SPROCKET 12 TOOTH LONG SHAFT KT100S or KT100J
$49.45
Tax included
Rotax 11 Tooth Sprocket Bush 233855
$15.95
Tax included
M10 Nyloc Nut Suit M10 Steering Column and M10 Kingpin
M10 Nyloc Nut Suit M10 Steering Column and M10 Kingpin
$0.75
Tax included
Bearing Hanger BLACK Suit 40mm and 50mm Axles
$54.95
Tax included
Side Pod Bar Suit most Karts - Left 500mm Centres 20mm...
Side Pod Bar Left NOTE: will fit Arrow and Monaco that have 20mm thick bars SOME are only 19mm.. Check before order Suit: Most Senior Karts
$110.00
Tax included
MAGNESIUM WET WEATHER RIM SET - Bearing Fronts
$349.95
Tax included
Number 0 decal Small black sticker Suit side pods
Kart number decal black small number 0 suit sidepods. Made in three layers for easy application from 3M ScotchCal. AKA approved font and size.
$1.85
Tax included
Sniper Camber Caster Adjuster Bottom Plate
Suit 8mm and 10mm King Pin version
SNIPER LOWER CASTER PLATE for
KING PIN CAMBER/CASTER ADJUSTER
PLEASE ENSURE THAT THE MOUNTING SECTION ON THE CHASSIS IS FLAT.
DO NOT OVER TIGHTEN THE COUNTERSUNK SCREWS USED TO SECURE IT TO YOUR KART.
THIS COULD LEAD TO A BREAKAGE OF THIS COMPONENT.
A locking fluid is recommended on the two countersunk screws