Kart Parts There are 239 products.

Active filters

  • Categories: Axles and Accessories
  • Categories: Data Loggers
  • Categories: Engine Parts - Cheetah
  • Categories: Hardware - Nuts Bolts Washes

40mm Axle Collar 2 pc split type each

40mm Go Kart Axle Retaining Collar Guarantee to release your Engine Power.   All keyway 8mm (so fit 6mm as well)

$19.45 Tax included

Bearing 30mm Axle Sealed. These are heavy duty rubber...

Bearing 30mm Axle Sealed. These are heavy duty rubber lip seal bearings. Great for dirt or wet weather.     ID = 30mm  OD = 62mm  SB206

$19.95 Tax included

Cheetah Crank Shaft Nut

17 mm nut, 2 per Cheetah engine 1 for the clutch drum, 1 for the flywheel. A small dot of thread glue is recommended during replacement

$3.95 Tax included

Cheetah Flywheel Woodruff Key Ignition side

Cheetah Flywheel Woodruff Key Ignition side. This is slightly thinner than the clutch side woodruff key

$6.95 Tax included

Exhaust Header IAME RL Leopard or Cheetah

Exhaust Header   Exhaust Header IAME RL Leopard or Cheetah   Aftermarket Kartelli Corse Header

$85.00 Tax included

Engine Mount Nut each

Engine mount manifold nuts. M10 thread, the nuts are captive inside the engine mount. Sold as each.

$2.60 Tax included

Stub Axle Bearing Spacer 8mm ID x 23mm Long

Stub Axle Bearing Spacer 8mm ID x 23mm Long   This is the spacer that goes between the top and bottom bearings in stub axle spindles

$3.49 Tax included

Blanking Plug For Temperature Sensor Hole

Blanking Plug for temperature sensor hole with copper washer   thread M10 x 1  ( standard fitting )

$8.95 Tax included