Kart Parts There are 152 products.
The Brake Clevis Clevis Clip Red M6 Right Hand Thread
Red Anodised Clevis and Clip Pin for the end of the brake rod to attach to the Brake Master Cylinder. M6 Right Hand Thread M6 Standard Right Hand Thread
GO KART WELD ON BEARING HANGER BRACKET FLANGE OFF-ROAD...
Weld On Bearing Hanger Bracket Type 3 Outer Bearing Hanger For repairs to a damaged karts or the home kart builder
M10 Nyloc Nut Suit M10 Steering Column and M10 Kingpin
M10 Nyloc Nut Suit M10 Steering Column and M10 Kingpin
Stub Axle Bearing Spacer 8mm ID x 23mm Long
Stub Axle Bearing Spacer 8mm ID x 23mm Long This is the spacer that goes between the top and bottom bearings in stub axle spindles
Bead Locks Kartelli Corse thumb tightening set of 12
Bearing 40mm x 80mm zz
Bearing 40mm x 80mm zz rear axle bearing Suit most karts ID ( inside diameter ) = 40 mm OD ( outside diameter ) = 80 mm
Bearing 50mm x 90 Axle Sealed. These are heavy duty...
Bearing 50mm x 90 Axle Sealed. These are heavy duty rubber lip seal bearings. Great for dirt or wet weather.
Brake Rod Clevis Pin 6mm
The Clevis Pin for the end of the brake rod to attach to the Brake Master Cylinder. 6mm
Ride Spacer Washers 3 Pack M8 4mm thick
Ride Height Spacers M8 4mm thick Install on either side of the stub axle on the king pin bolt pack of 3
Tie Rod Rose Joint M8 PHS8L Left Hand Tread
Tie Rod Rose Joint M8 Left Hand Tread Suit older style tie rods
Seat Washers Counter Sunk Alloy Black Anodised Pack...
